Chem-Set™ C-30 Marblemaster "Dripless" Seaming Adhesive - Legacy Colors
PLEASE NOTE: The "Legacy" colors are being discontinued. Availability will vary as supplies last. Click here for the new line of colors: https://www.chemical-concepts.com/chem-set-c-30-marblemaster-dripless-seaming-adhesive.html
Color match may vary with manufacturer's lot variations. Information is provided as a reference only; end user should verify suitability prior use.
Solid Surface materials often require color matched adhesives for fabrication and installation. Chemical Concepts has a wide variety of colors to help create and install your countertops and vanities. Used with a gun and tips to make your install easy. One cartridge will dispense approximately 40 feet 1/4" bead. C-30 Marblemaster is a two-part methacrylate, super flexible, dripless/non-sag, low shrink, low exotherm, ultra violet light stable, non-yellowing hard surfacing adhesive designed for the nearly seamless bonding of Porcelain, sintered stone, glass, engineered stone, marble and quartz, and natural stone products. Combined at a ratio of 10:1 (10 parts resin, one part activator), C-30 has a working time of 10 to 15 minutes, with a 5 to 10 minute De-Roping Time, and achieve nearly 90 percent of its ultimate strength in 45 to 60 minutes at room temperature curing. C-30 offers a combination of high strength, stiffness, and toughness as well as the ability to bond very strongly to a wide variety of hard surface or inorganic materials. When combined with the proper use of ChemSet's ProBond surface cleaner/activator, C-30 provides high strength bonds to virtually any stone, engineered stone or quartz or granite products, including porcelain, sintered stone, and glass. With the use of ProBond, stone fabricators can bond successfully to wet stone, although bonding underwater is not permitted or recommended. C-30 permits the seasoned fabricator the opportunity to apply the adhesive to vertical surfaces, as well as horizontal surfaces, without dripping, and upon gelation, give the fabricator an extended window (5 to 10 minutes) to de-rope, or trim with a single bladed straight edge razor blade, the excess from the stone slab without ripping the adhesive out of the joint, nor damaging the surface of the stone.