Techcon 400 Series Receiver Head, 6cc Taper

Description

The Techcon 900-500-R receiver head is the fitting that joins a 400 Series 6cc syringe barrel to the air line running from a dispensing controller or regulator. Air pressure passes through the receiver head into the barrel to push adhesive, ink, or grease out through the tip, and the taper style fitting on this unit seats directly onto the barrel without an inline hose section. A Viton O-ring inside the head seals the connection against the pressures typical of syringe dispensing work.

Where the Techcon 900-500-R receiver head Fits

Assembly lines running Techcon syringe barrels for dot dispensing, potting, or conformal coating rely on the receiver head as the wear part that takes the repeated connect and disconnect cycles between barrel changes. Because the taper fitting mates straight to the barrel, this version suits stations where the controller or regulator sits close to the dispensing head and a hose run is not needed. Electronics assembly, small parts bonding, and any job cycling through 6cc barrels throughout a shift are typical uses.

Pressure Rating and Handling

Maximum operating pressure on this fitting is 100 psi (6.9 bar), which covers the working range for most syringe dispensing applications without a booster. Inspect the Viton O-ring for nicks or flattening whenever a barrel connection starts leaking air, since a worn O-ring is the most common reason a receiver head loses seal before the taper fitting itself wears out. Keep the taper surface free of cured adhesive so the next barrel seats fully rather than sitting proud on debris.

Product Specifications

Pair this receiver head with matching 400 Series barrels and tips from the Dispensers, Mixers and Nozzles line. Techcon publishes the full 400 Series receiver head and caps lineup on its manufacturer site at techcon.com.

Need Help?

Need help matching a receiver head to your barrel and controller setup? Call (800) 220-1966 or email [email protected].