Techcon TS616-HO-LD-1000 6 in LDPE Nozzle, 1/16 in Orifice, 1000 Pack

Description

Techcon TS616-HO-LD-1000 6 in LDPE Nozzle, 1/16 in Orifice, 1000 Pack

This dispensing needle style nozzle is a six-inch high-output LDPE cartridge nozzle for placing adhesive, sealant, potting compound, or other compatible process fluids from Techcon cartridges and equivalent cartridge systems. The long nozzle body helps reach into assemblies, housings, joints, and other areas where a short dispense tip would limit access or visibility.

dispensing needle nozzle design

The nozzle is precision molded from natural low-density polyethylene and uses a 1/4 in NPT male thread to fit Techcon cartridges or equivalent setups. Six-inch nozzles are commonly selected when the material path needs extra reach, when operators need clearance around fixtures, or when a longer tip helps place fluid inside deeper part geometry. Related dispensers, mixers and nozzles can support the rest of the dispensing station.

TS616-HO-LD-1000 specifications

dispensing needle selection notes

Use the 1/16 in orifice when the process calls for that flow opening and confirm it against the material viscosity, pressure setting, and target bead or fill size. The bulk 1,000-count packaging is a strong fit for established production cells, kit builds, and replenishment programs where the same nozzle is consumed regularly. A longer nozzle can change how the operator approaches the workpiece, so trial the reach and angle before locking the part into a fixture or work instruction. Confirm that the nozzle length does not add unwanted resistance for the selected material, especially when moving from a short tip to a six-inch format.

Application fit

This nozzle is intended for cartridge-based dispensing where reach, repeatability, and a clean replacement path matter. For more on Techcon dispensing products, visit Techcon.

Need Help?

Call (800) 220-1966 or email [email protected] for help confirming nozzle length, orifice, and cartridge fit.