Description
These dispenser parts carry compressed air from the shop supply to a Techcon TS950 series pneumatic sealant gun, and this is the 20 ft version with a Hansen quick-connect fitting on the end. The TS950 is a palm-grip cartridge gun rated for 100 psi service, and it needs a dedicated air line like this one to fire consistently at a fixed pressure rather than pulling from a shared shop drop that fluctuates under load.
Where These Dispenser Parts Fit in a TS950 Setup
Production cells running a TS950 gun on a bench, a fixture, or a mobile cart use the 20 ft length to reach across a workstation without dragging the compressor or regulator closer to the operator. The Hansen fitting is a standard quick-connect, so the hose disconnects for a shift change or a gun swap without tools. Any of these dispenser parts sees regular flexing at the connector end, which is the point most worth a visual check before each shift.
How These Dispenser Parts Hold Up in Daily Use
The hose is rated to match the TS950’s 100 psi operating pressure, and the Hansen connector seals reliably through repeated connect and disconnect cycles, holding up better than a threaded fitting under the same daily use. A kinked or cracked hose shows up as inconsistent gun pressure or a slow trigger response, both signs it is due for replacement rather than a fix at the regulator.
| Spec | Detail |
|---|---|
| Length | 20 ft |
| Fitting | Hansen quick-connect |
| Rated pressure | 100 psi |
| Compatible guns | Techcon TS950 series and 100A series pneumatic cartridge guns with Hansen fitting |
Order this hose as a maintenance spare for any shop running a TS950 gun daily, or as the primary air line when setting up a new station. Browse Chemical Concepts dispensing valves, mixers, and nozzles for the full TS950 lineup, or see the complete Techcon pneumatic dispensing system.
Need Help?
Need help matching hose length or fitting type to your TS950 station layout? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.