ChemSet 749K Dishwasher Mount Kit (2 Sets of Hardware + 633 Epoxy)

$7.89
SKU
CCH749k

ChemSet 749K Dishwasher Mount Kit (2 F1CT + 633 Epoxy Adhesive) contains Undermount Studs and Sink Clips as well as our ChemSet 633 Epoxy, Dispense Gun and Mixing Nozzles to securely mount sinks and dishwahers under any counter surface without drilling.

Benefits:

  • Use with natural stone (granite, marble, concrete, wood)
  • No special glues needed–Stud base glues to underside of counter, using epoxy
  • 1-1/2" Diameter stud base is designed to fit into tight areas
  • Sinks are easily installed, using the included wing nuts, lock washers and sink clips
  • Each Undermount Stud set includes 4 sets of hardware + 2 extra sets of hardware for dishwasher installation

Each Kit will Contain:

Instructions:
  1. Remove cap from 633 Epoxy Adhesive - Dispense a small amount of adhesive until adhesive is flowing from both sides (A&B)
    • 25ml Hand Syringe: Push adhesive out in equal amounts in provided mixing cup and mix thoroughly with mixing stick until the color is completely uniform
  2. Clean the area to be bonded and the Glue-On Fastener with alcohol. Surface must be clean and dry for good adhesion
  3. Carefully apply 633 Epoxy to the base of the Glue-On Fastener or and set in desired position on the underside of the countertop around the sink cut-out
  4. Allow 45 minutes - 1 hour for adhesive to reach proper handling strength
    • Note: Adhesive will continue to cure for up to 24 hours
  5. Once adhesive has reached handling strength place your dishwasher into position and thread the screw through you dishwasher tabs
Write Your Own Review
You're reviewing:ChemSet 749K Dishwasher Mount Kit (2 Sets of Hardware + 633 Epoxy)