LORD Accelerator 19

$94.01
SKU
LORD Accelerator 19

Description 

LORD Accelerator 19 and 19GB are mix-in curatives designed for use with LORD acrylic adhesives. LORD Accelerator 19 and 19GB, when mixed with LORD 200, 400 or 500 series acrylic adhesives, create adhesive systems that will bond a variety of prepared or unprepared metals and plastics. LORD Accelerator 19GB allows precise control of adhesive bondline thickness due to its content of glass beads, 0.01” (0.025 cm) diameter.

Features and Benefits 

Convenient– provides room temperature cure with all LORD acrylic adhesives

Environmentally Friendly– contains no solvent, nonflammable and virtually odorless.

Environmentally Resistant– resists common environmental conditions when used with LORD acrylic adhesives.

Temperature Resistant– improves high temperature resistance of LORD 200, 400 and 500 series acrylic adhesives.

 

Application 

Mixing–Confirm the proper mix ratio of acrylic adhesive to accelerator by consulting the appropriate LORD acrylic adhesive data sheet. Thoroughly mix the proper amount of adhesive and accelerator until uniform in color and consistency. Be careful not to whip excessive air into the adhesive system.

Heat buildup due to an exothermic reaction between the two components will shorten the working time of the adhesive. Mixing smaller quantities will minimize heat buildup.

Applying–Apply adhesive to substrate surfaces using handheld cartridges or automatic meter/mix/dispense equipment. Mate the parts within the working time of the adhesive. Clamp in position until handling strength is achieved

Curing–– Handling strength and complete cure times will vary depending on acrylic adhesive used. For cure times, refer to appropriate acrylic adhesive data sheet

Appearance Off-White Paste
Viscosity, cP @ 77°F (25°C) 150,000-450,000
Density lb/gal (kg/m3) 12.15-12.7 (1456-1522)
Solids Content by Weight, % ) 99.08
Flash Point (Seta), °F (°C) >200 (>93)
Write Your Own Review
You're reviewing:LORD Accelerator 19