3M Trizact Hookit II A10 Blue Sheet, 11 Inch

Description

Trizact A10 sheet is an 11 inch blue Hookit II finishing abrasive for stone, concrete, glass, and solid surface work. It uses 3M Trizact microreplication technology, where micron-graded aluminum oxide is formed into uniform pyramids that expose fresh mineral as the sheet wears.

Trizact A10 sheet Benefits

• A10 grade gives crews a controlled finishing step between heavier scratch removal and final polish.
• Hookit II attachment helps operators change sheets quickly on compatible pads.
• Microreplicated mineral supports a consistent cut over the working life of the abrasive.
• Water-resistant film backing supports damp sanding when the process calls for cooler cutting and debris removal.
• Blue grade identification helps crews keep the finishing sequence clear on the shop floor.

This abrasive is used to restore and condition stone and concrete floors, and it can also support solid surface and glass finishing sequences where a predictable scratch pattern matters. Keep the sheet matched to the pad, machine speed, and substrate so the finish stays even across the whole work area.

Trizact A10 sheet Selection

• Refining stone or concrete before a finer finishing step.
• Reducing visible scratch marks on solid surface tops.
• Damp sanding glass or acrylic when the process has already been tested.
• Preparing a smooth, refined surface before polishing compound.
• Maintaining a color-coded abrasive sequence for multi-step floor work.

Surface Preparation And Use

Remove loose grit, dust, and slurry before starting a finer grade. Use clean water when damp sanding is part of the process, and keep the sheet flat against the work so high spots do not receive uneven pressure.

Test the sequence on a small area before committing to a floor, panel, or countertop. Replace the sheet when cut rate drops or contamination could drag coarse particles into the next step.

Technical Details And Documentation

3M describes Trizact Hookit Film Sheet 268XA as a water-resistant polyester film abrasive with microreplicated aluminum oxide mineral and a grade range where lower A grades are finer. Review the current 3M page for Trizact Hookit Film Sheet 268XA before setting a production finishing sequence.

Ordering Help

For related finishing sheets, pads, and surface prep supplies, browse Chemical Concepts abrasives. For help matching A10 to the next finish step, call (800) 220-1966 or email [email protected].