Description
This 150ml pneumatic dispenser is a hand-held, air-powered gun built for 150 x 150 ml dual cartridges at a fixed 1:1 mix ratio. Shop air drives the piston rod through both cartridge barrels at the same rate, so operators get steady, consistent output pull after pull instead of the uneven flow that comes from squeezing a manual caulking-style gun by hand.
Why Shops Move to a 150ml Pneumatic Dispenser
Two-part epoxies, urethanes, and structural adhesives packaged in 150 x 150 ml cartridges set up fast once mixed, so a steady dispense rate matters more than it does with slower-curing products. An air-powered trigger keeps the ratio accurate through the whole cartridge, which cuts down on off-ratio waste at the start and end of a pass compared with a manual gun.
Running the 150ml Pneumatic Dispenser
Connect the gun to a regulated shop air line, load a fresh 150 x 150 ml cartridge with the static mixer attached, and use the trigger to control flow rather than holding it wide open, especially on the first stroke of a new cartridge. Bleed air from the lines before the first dispense of the day so trapped air does not throw off the initial mix ratio. A quick bleed cycle only takes a few seconds and saves a full cartridge of two-part adhesive if the ratio drifts on the first pull.
| Spec | Detail |
|---|---|
| Cartridge Size | 150 ml x 150 ml dual cartridge |
| Mix Ratio | 1:1 |
| Power Source | Shop air (pneumatic) |
| Model | 304 |
| Country of Manufacture | United States |
Chemical Concepts stocks static mixers, cartridges, and accessories to match in the dispensers, mixers, and nozzles category. This dispensing platform is part of the Lord family of adhesive equipment now under Parker Hannifin’s engineered materials group. For help matching this dispenser to a specific two-part adhesive or ordering replacement parts, call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.