Description
The Techcon cleaning brush clears cured fluid, dried adhesive, and residue from dispensing valve bores, syringe barrels, and fittings on a benchtop dispensing setup. Most dispensing faults trace back to a partially blocked path, and a quick pass with the brush during changeover keeps the bore open and the shot consistent.
Where the Techcon cleaning brush fits
- Routine cleanout of valve bodies and fluid paths between fluids or shifts.
- Clearing partially cured adhesive or epoxy before it sets hard.
- Maintenance of syringe barrels, adapters, and fittings on the bench.
Run the brush through the bore with a compatible solvent, then flush and dry before the next fluid goes in. Catching residue early avoids a teardown later and keeps deposit size where you set it.
How the Techcon cleaning brush helps
- Sized for dispensing valve and fitting bores on TS series equipment.
- Pairs with a compatible cleaning solvent for the fluid being removed.
- A low-cost maintenance item that protects more expensive valves and tips.
Dispensing problems usually show up as a dwindling or erratic shot well before they become a hard blockage. Brushing the bore at changeover, rather than waiting for a stall, is the cheapest maintenance on the bench. Pair the brush with the right solvent for the fluid in use, work it through the bore, then flush and dry so no cleaner carries into the next fluid. Rinsed and dried after each use, one brush lasts across many cleanouts.
Build the brush into a written cleanout step so every operator runs the same routine, and log the solvent used so the next shift can repeat the cleaning safely. For dispensers, valves, and related consumables, see our dispensers, mixers, and nozzles. Equipment and maintenance references are published by Techcon.
Need Help?
Need help building a cleanout routine for your dispenser? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.