ELANTAS CONAPOXY FR-1080 Epoxy Potting Kit, 1 Gallon

Description

CONAPOXY FR-1080 is a two-part epoxy potting kit supplied in a 1 gallon package for electrical and electronic protection work. It is used for encapsulation where high-temperature service, low mixed viscosity, and hard cured epoxy protection are required.

CONAPOXY FR-1080 Benefits

• Low 2,500 cP mixed viscosity helps the material flow into coils, windings, and module cavities.
• Two-part epoxy chemistry gives a hard, 90D cured material for rigid encapsulation.
• High-temperature electronic protection fit supports devices built for demanding service.
• Kit packaging keeps resin and hardener paired for purchasing and inventory control.
• Unfilled system can be useful where lower viscosity is more important than filled abrasion control.

This product is a fit for electrical potting work where the encapsulant must reach around fine geometry and cure into a hard protective mass. Confirm cure schedule, thermal rating, and electrical requirements against the current technical sheet before changing an approved design.

CONAPOXY FR-1080 Applications

• Potting and encapsulation of electrical and electronic devices.
• Transformer, coil, and module protection where epoxy rigidity is desired.
• High-temperature electronic protection projects using a two-part epoxy system.
• Bench potting work that benefits from low initial mixed viscosity.
• Production casting where a 1 gallon kit supports repeatable material staging.

Surface Preparation And Use

Dry and clean assemblies before potting. Remove flux residue, dust, oil, and trapped moisture that could affect electrical performance or cure quality. Warm components only within the limits of the assembly and material data.

Mix the resin and hardener in the specified ratio, scraping the sides and bottom of the container. Degas when voids would reduce dielectric performance or leave air around wire windings. Verify cure time and temperature on the actual part mass before production release.

Technical Details And Documentation

ELANTAS lists CONAPOXY FR-1080 within its epoxy potting materials with 2,500 cP initial mixed viscosity at 25 degrees C and Shore D hardness of 90. Other published material references identify it as a two-part epoxy potting and encapsulation compound for electrical devices. Review current product-family information from ELANTAS before use.

Ordering Help

For related electronic protection materials, browse Chemical Concepts encapsulants and potting compounds. For help comparing viscosity, hardness, and cure schedule, call (800) 220-1966 or email [email protected].