Description
The No Drill Bonding Fastener F1-SB30 is a Chem-Set female hex nut mounted on a round 30 mm baseplate, 1.2 mm thick, built to bond to a surface with adhesive instead of a through-drilled hole. It gives fabricators a threaded attachment point on glass, stone, composite, and other panels where drilling would risk cracking the substrate or is not allowed by the material warranty.
Where the No Drill Bonding Fastener Gets Used
This baseplate style fastener shows up on signage, glass railing hardware, countertop accessory mounts, cabinet hardware, and any assembly where a threaded stud or bolt needs to anchor into stone, glass, or solid surface material without a mechanical hole through the panel. Because the hex nut sits on a flat round base, installers bond it with a structural adhesive and get a clean threaded point for a bolt, standoff, or bracket on the finished side.
The F1-SB30 ships as a female hex nut, so the mating hardware is a male bolt or threaded stud rather than a separate nut, which keeps hardware count down on an install. Four thread sizes cover most fabrication hardware call-outs: 10-24, 10-32, 1/4-20, and 3/8-16, and each is available in thread lengths from 0.250 inch up to 3.000 inches.
How the No Drill Bonding Fastener Holds Up
Because the bond relies on adhesive contact across the full 30 mm baseplate rather than a mechanical fastener through the material, joint strength depends on proper surface prep and a compatible structural adhesive for the substrate. Bonded correctly to stone, glass, or solid surface, the flat baseplate spreads load across a wide contact area instead of concentrating it at a single drilled point, which is part of why fabricators reach for this style on brittle or warranty-sensitive materials. Available base materials and plating options let a fabricator match corrosion resistance and finish to the application.
No Drill Bonding Fastener F1-SB30 Specifications
| Property | Value |
|---|---|
| Type | Female hex nut, bonded baseplate |
| Baseplate | 30 mm round, 1.2 mm thick |
| Thread sizes | 10-24, 10-32, 1/4-20, 3/8-16 |
| Thread lengths | 0.250 in to 3.000 in |
| Mounting method | Structural adhesive bond, no drilling |
| Typical substrates | Glass, stone, solid surface, composite panels |
Pair this fastener with a compatible structural adhesive from the Chemical Concepts bonding fasteners category for a complete no-drill mounting solution. For bonding technique and cure time guidance on Chem-Set fasteners, see the Chemical Concepts YouTube channel.
Need Help?
Need help matching thread size and adhesive to your panel material? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.