Techcon TS416 Bent Nozzle, 80 Deg X 1.5 In, Qty 1000

Description

The Techcon TS416 bent nozzle attaches to a standard luer-lock syringe or cartridge tip and redirects fluid flow 80 degrees partway down a 4 inch shaft, letting an operator reach into a recess or around an obstruction that a straight dispensing needle cannot clear. The bend sits 1.5 inches from the base, positioning the working tip close enough to the target for accurate placement without forcing an awkward syringe angle. This listing covers a case quantity of 1000, sized for production lines that go through nozzles daily rather than a bench that dispenses occasionally.

Where This Dispensing Needle Fits

• Potting and encapsulation work inside enclosures, connector housings, or recessed cavities
• Underfill and edge-bond dispensing where a straight tip cannot clear surrounding components
• Precision adhesive placement on PCB assemblies with tall components blocking a straight approach
• Any application where the tip has to angle around a wall, lip, or ledge to reach the bond line

Dispensing Needle Specifications

• Overall length: 4 inches
• Bend angle: 80 degrees
• Bend position: 1.5 inches from the base
• Fitting: standard luer-lock connection
• Packaging: box of 1000, single use per tip recommended for cross-contamination control

Order this dispensing needle alongside the matching straight-tip version so a production cell can switch between straight and bent access points without waiting on a reorder. Match the inner diameter to the fluid viscosity on the job. A narrower bore controls bead size on fine work but raises back pressure on higher-viscosity fluids, so confirm the bore spec fits the dispensing equipment already on the line. Techcon molds these tips from a rigid polypropylene that resists most solvents and cured adhesive residue, and the luer-lock thread is the same standard used across most syringe barrels and cartridge adapters on the market, so cross-brand compatibility is rarely a concern. See the full nozzle and tip range at Techcon, or browse related accessories in the dispensing, mixers and nozzles category.

Need Help?

Need help picking a bend angle or bore size for a recessed dispensing job? Call (800) 220-1966 or email [email protected].