Techcon TS616 Bent Nozzle, 30 Degree x 1.5 In

Description

This Techcon TS616 bent dispensing needle angles 30 degrees at a 1.5 inch offset, letting the tip reach into recessed features, over standing components, or around fixture edges that a straight nozzle cannot clear. It fits Techcon TS-series cartridges and equivalent syringe barrels, so it drops into an existing dispensing setup without changing the barrel or valve feeding it.

Why this dispensing needle beats a straight tip here

Straight nozzles work fine on flat, open assemblies, but many electronics, automotive, and appliance assemblies have a wall, connector, or housing edge in the direct line of the dispense point. A 30-degree bend at 1.5 inches lets the operator or robot approach the target at an angle instead of repositioning the whole part, which keeps cycle time down on repetitive tip-and-valve work. The precision-molded bend holds its angle under normal handling and dispensing pressure, and the low-density polyethylene construction resists most common solvents and adhesive chemistries.

Bent tips in this family are sized to fit standard Techcon cartridge threads, so switching from a straight nozzle to this bent configuration mid-run does not require a different barrel, adapter, or valve. That interchangeability is useful on lines that dispense the same fluid onto several different part geometries in a single shift, since operators can swap tips rather than reprogramming a whole dispensing head.

Specifications

Stocking this dispensing needle at Chemical Concepts

Chemical Concepts carries this bent tip alongside straight and specialty Techcon dispensing needles, valves, and mixers, so you can standardize on one supplier for cartridges, tips, and the valves that feed them. Call (800) 220-1966 or email [email protected] if you need a different bend angle or offset for a specific fixture. Techcon’s dispensing tips and needles catalog lists the full range of bent and straight configurations built on this same platform.