Techcon Viton O-Ring, 1/8 in ID x 1/16 in CS

Description

This Viton O-ring pack supplies small dispensing valve parts for Techcon maintenance work where the bill of materials calls for a fluorocarbon seal. The ring size is 1/8 in inside diameter by 1/16 in cross section, supplied as a 10 pack so a technician can rebuild several compatible sealing points without opening a new order for every service event.

Where dispensing valve parts like this fit

A compact O-ring often does quiet work inside a valve, fitting, receiver head, or fluid-path interface. When that seal hardens, swells, nicks, or takes a compression set, a station may start dripping between cycles or losing pressure during a timed shot. Viton, commonly associated with FKM fluorocarbon materials, is selected in many industrial sealing applications for chemical and temperature resistance compared with general-purpose rubber. Compatibility still depends on the exact adhesive, solvent, cleaner, and operating conditions in the dispense cell, so confirm the material before putting a rebuilt valve back into service.

The 1/8 in ID and 1/16 in cross section create a small sealing profile for compact hardware. That makes correct installation important. A ring that is close in size but not exact can pinch, extrude, or leave a leak path after the fitting is tightened. Keep this pack with the rest of the valve service spares so technicians can replace like-for-like instead of borrowing an unknown seal from another kit.

How these dispensing valve parts are installed

• Pack quantity: 10 O-rings.
• Material: Viton rubber.
• Size: 1/8 in ID by 1/16 in cross section.
• Use case: replacement seal for compatible Techcon dispensing hardware.
• Maintenance role: service stock for valve and fitting rebuilds.

Remove the old ring without scratching the gland, then wipe away cured adhesive, dust, and residue from the sealing surface. Seat the replacement evenly, check for twists, and tighten the mating hardware straight so the seal compresses around the full circumference. After reassembly, test at low pressure before returning the station to production. For related valves, seals, fittings, syringes, and accessories, browse Chemical Concepts dispensers, mixers, and nozzles. Techcon product family information is available from Techcon.

Need Help?

Need help confirming the right O-ring material for your process fluid? Call (800) 220-1966 or email [email protected].