Sikagard FlexCoat System 55 LB Bag & 2.5 Gallon Unit

Description

Sikagard FlexCoat is a Two-component, polymer-modified, waterproof, cement-based coating system cementitious protective coating. It consists of a unique rubber-like polymer liquid (Part A) mixed at the time of application with a cement aggregate blend (Part B).

• It can be applied over almost any clean, sound surface e.g. concrete, block, masonry, etc. for a number of different floor, wall and roof uses.
• Extraordinary adhesion coupled with its ability to withstand prolonged pedestrian and light vehicular traffic. In these respects, the material is far superior to conventional cementitious coatings.
• Provides a waterproof coating which substantially reduces or prevents water penetration, freeze-thaw scaling and concrete carbonation.

Usage:

• Balcony deck surfacing
• Concrete exterior restoration
• Sidewalk resurfacing
• Wall refinishing and installation coating
• Stadium renovation
• Swimming pool walkways

Advantages:

• It can be applied over almost any clean, sound surface e.g. concrete, block, masonry, etc. for a number of different floor, wall and roof uses.
• Extraordinary adhesion coupled with its ability to withstand prolonged pedestrian and light vehicular traffic. In these respects, the material is far superior to conventional cementitious coatings.
• Provides a waterproof coating which substantially reduces or prevents water penetration, freeze-thaw scaling and concrete carbonation.
• “Breathable” coating which releases normal entrapped vapor without loosening or blistering.
• Available in natural cement color.
• Sikalastic® Traffic Systems can be top coated with Sikagard® FlexCoat cement based systems. Please refer to the spec component of the Sikalastic®/Sikagard® Flexcoat Hybrid System.

Packaging: 

• Each kit contains:
  • 55 ln (25 kg) bag
  • 2.5 gal (9.5 L) liquid

Coverage: 250 ft²/coat/unit

Mixing:

• Place the liquid component in appropriate mixing container.
• It is always recommended to start mixing with approximately 80 % of the liquid.
• Add the powder while continuing to mix with a low-speed drill (400–600 rpm) and paddle.
• Mix to a uniform consistency, maximum 3 minutes.

Application:

• Pre-wet surface to SSD (Saturate Surface Dry).
• Insure good intimate contact with the substrate is achieved.
• Sikagard® FlexCoat can be applied in multiple coats by brush, roller, trowel or spray to a typical thickness of 60 mils (1.5 mm).
• Apply first coat of Sikagard® FlexCoat.
• Apply following coats (one or two depending on service conditions/ requirements) by brush, trowel roller or spray.
• Finish to specified texture.
• Protect newly applied Sikagard® FlexCoat from direct sunlight, wind, rain and freezing.
• Color Finish (optional) – apply Sikagard ® FlexCoat ATC acrylic top coat for color finish, when specified, in two coats by roller, brush or spray.