Description
The Sta’-Put ST6502 spray gun tip sets the spray pattern and flow rate on canister-fed contact adhesive guns. It runs a 65 degree spray angle at 1.0 gallon per minute, which lays down an even web of adhesive across panels, laminate, and upholstery substrates without flooding the surface.
Where the ST6502 spray gun tip fits
Canister spray adhesive systems depend on the right tip to control coverage. The 65 degree angle suits flat and broad surfaces like countertop laminate, wall panels, foam, and fabric lamination, where a wide fan keeps the bond line consistent. Shops running high-volume lamination move to this tip when they need faster coverage than a narrow-angle tip delivers. The 1.0 GPM flow rate matches medium to high output canister work. Pair it with the matching canister gun and hose so spray pressure and adhesive flow stay in balance.
How the ST6502 spray gun tip holds up
The tip threads onto the gun body and seats with a clean seal, so pressure stays steady through the spray. Brass and steel construction resists wear from solvent-borne adhesives and repeated trigger cycles. Clean the tip with the recommended solvent after each session to keep the orifice clear and the fan pattern even. A consistent fan also cuts overspray and adhesive waste across a production shift.
Specifications
| Specification | Detail |
|---|---|
| Spray angle | 65 degrees |
| Flow rate | 1.0 GPM |
| Fits | Canister-fed contact adhesive spray guns |
| Construction | Brass and steel |
| Typical use | Laminate, panel, foam, and fabric lamination |
Match the tip angle and flow to the adhesive and the surface area you spray most. Browse our dispensers, mixers, and nozzles for replacement guns, hoses, and tips. For background on spray contact adhesive application and surface prep, see the Adhesive and Sealant Council adhesives overview.
Need Help?
Need help matching a spray tip angle and flow rate to your canister system? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.