Techcon TS5130 Controller Timer Board

Description

The Techcon TS5130 controller timer board is a replacement dispensing valve parts component for a timed valve-control station. It belongs inside the TS5130 controller assembly, where the timing circuit helps turn an operator input into a repeatable dispense cycle for adhesive, sealant, coating, or lubricant work.

Where dispensing valve parts like this are used

Timed controllers matter when a bench or automated fixture needs the same valve open time over and over. A failed timer board can show up as missed cycles, unstable shot timing, or a controller that will not respond cleanly to a foot switch or machine signal. Replacing the board keeps the repair focused on the controller instead of replacing the full station, provided the power supply, enclosure, wiring, and connected valve have already been checked by qualified maintenance staff.

This item is not a mixing nozzle, 2 part mixing nozzle, or jb weld mixing nozzle. It is an internal electrical service part for a Techcon dispensing controller. Keep it with controller spares, valve cables, foot switches, and other service components rather than storing it with wet-end consumables.

dispensing valve parts specifications

Before release, confirm the controller model and failure mode. Electrical service should be handled with the controller powered down and removed from the air and valve circuit. Label the old board, note connector locations, and inspect harnesses for bent pins, heat marks, or loose terminals before the replacement is seated. If the connected valve is still slow or inconsistent after the controller is repaired, check the fluid path, air supply, and valve seals next. Browse related dispensers, mixers, and nozzles for Techcon valve accessories and service parts. Techcon publishes current dispensing platform information at Techcon.

Because the timer board is inside the controller, it should be handled as an electrical repair item rather than a fluid-contact replacement. A maintenance team can use this part when a known TS5130 unit still has a sound case and pneumatic hardware but no longer provides dependable timing control. It is a practical shelf item for plants that run older controller platforms and want to avoid taking a valve station offline while a full controller is sourced. Keep anti-static handling practices in place, and verify model labels before installation so the board is not mixed with parts for a different controller family.

After replacement, test the controller with air only before reconnecting material. Start with a simple timed cycle, confirm that the foot switch or machine input starts and stops the output cleanly, then reconnect the valve and material feed. That sequence keeps troubleshooting orderly and helps separate controller faults from clogged tips, worn seals, weak air supply, or material changes.

For stocking, treat this as a low-volume service component with high downtime value. One failed timing board can idle a complete dispense cell, so it is worth matching controller spares to the exact controller families still active on the floor.

Need Help?

Need help confirming whether the controller, cable, or valve is causing the timing issue? Call (800) 220-1966 or email [email protected].