Description
The Techcon TS5322 valve body is the main replacement housing for a TS5322 mini spool dispensing valve. It supports the fluid path, outlet block, seals, and spool movement that let the valve place controlled beads or shots of adhesive, sealant, coating, grease, or other medium to high viscosity material.
Where this dispensing valve body fits
The TS5322 platform is a compact spool valve used when lower-pressure precision is needed in a benchtop station or automated fixture. The valve uses a balanced spool action for fast on and off control, and the shutoff stroke creates suck-back to reduce drip at the tip. A damaged or worn body can disturb that motion, especially if threads, seal bores, or the outlet interface have been scratched during cleaning.
Use this body when repair inspection points to the housing rather than a simple seal, O-ring, or adaptor issue. If the valve has inconsistent deposits, first confirm fluid pressure, air pressure, tip condition, and controller timing. When the body itself is the source of leakage, poor sealing, or front-section damage, replacing it can bring the valve back into a controlled repair path.
dispensing valve specifications
| Property | Value |
|---|---|
| SKU | TEC5320-000-002 |
| Brand | Techcon |
| Part type | Valve body |
| Valve fit | TS5322 mini spool valve |
| Guide item | Item 23 in TS5322 spare parts |
| Fluid ports on valve platform | 1/8 NPT inlet and outlet |
| Unit of measure | Each |
For a clean rebuild, pair the replacement body with the correct seal kit and inspect the spool/piston assembly while the valve is apart. Keep dry seals dry where the service guide calls that out, and lubricate only the specified O-rings and seals during reassembly. Do not force the air cylinder or outlet block if cured material is holding the front section together. Browse related dispensers, mixers, and nozzles for repair parts that support Techcon valves. Current platform details are available from Techcon.
The TS5322 body is deeper in the repair decision than a tip, adaptor, or front seal. It should be selected when inspection shows physical damage to the housing or when repeated rebuilds no longer restore consistent shutoff. In automated cells, this part can protect uptime because a damaged body can make a good controller, good air signal, and fresh tip behave as if the whole system is out of tune.
Store the body as a model-specific service component. The TS5322 and TS5322D versions use different material construction, and repair parts should match the valve already installed on the machine. After assembly, test with low-risk material or a compatible purge process before production fluid is introduced. That check confirms the spool moves freely, the outlet block seats squarely, and the deposit response is stable before operators return to normal shot settings.
Because the body anchors the wet-end assembly, avoid mixing old damaged screws or distorted seals into the rebuild. A clean hardware stack gives the replacement housing its best chance to seal evenly.
Need Help?
Need help deciding whether to replace the valve body, seal kit, or spool assembly? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.