Techcon TS1212 Short Pinch Tube, 0.100 in ID, 10 Pack

Description

The Techcon TS1212 short pinch tube pack is replacement dispensing valve parts tubing for pinch-tube dispensing valves used with low to medium viscosity fluids. The tube is the disposable wetted path that the valve opens and closes during each dispense cycle. When the controller sends an air signal, the valve opens the tube and lets material flow. When the signal stops, the spring closes the tube again, helping stop dots and beads without exposing the valve body to the fluid.

Where these dispensing valve parts fit

This short 0.100 in ID tube belongs with TS1212 pinch valve service kits and maintenance carts. Pinch-tube valves are useful for cyanoacrylates, two-part materials, primers, coatings, oils, lubricants, and sealants because the material contacts the tube rather than the internal valve hardware. Keep replacement tubes near compatible fluid lines, tips, and controller parts, while separating them from mixing nozzle, 2 part mixing nozzle, and jb weld mixing nozzle stock used on static-mixer cartridge systems.

Tube details and specs

Ordering these dispensing valve parts

Replace pinch tubes during routine service, after material changes, or whenever a tube has taken a set from repeated pinching. A fresh tube helps restore consistent shot size and keeps reactive material away from the valve body. Browse related dispensers, mixers, and nozzles for compatible tips, valves, and tubing. For TS1212 valve background, visit Techcon.

For service planning, match the part number to the equipment bill of materials, inspect the surrounding hardware before reassembly, and keep a small labeled spare bin for repeat repairs. That habit prevents a low-cost connector, tube, or kit component from stopping a bench while the larger valve or controller is otherwise ready to run.

Need Help?

Need help matching pinch tube ID, material, or valve family before ordering? Call (800) 220-1966 or email [email protected].