Techcon TS934A Material Inlet Block, 1/4 NPT Aluminum

Description

The aluminum material inlet block gives the Techcon TS934A spool valve its fluid entry port, threaded 1/4 NPT for a standard fitting connection from a pressure pot or cartridge feed. This dispensing valve parts component bolts to the valve body and routes incoming adhesive, sealant, or potting compound into the spool bore.

Where this dispensing valve parts component fits

Material inlet blocks wear at the thread and seal face faster than the valve body itself, especially on lines running abrasive or high-viscosity fluids. Rebuild crews replace the block when thread galling or seal groove wear shows up during a scheduled teardown. TS934A valves feeding a static mixer, a mixing nozzle, or a 2 part mixing nozzle downstream see this inlet block on every shot, and a line finishing through a jb weld mixing nozzle for structural repair work puts the same wear pattern on the block regardless of which mixing nozzle follows. Because the block bolts on as a separate assembly, a worn thread or scored seal face does not require scrapping the whole valve body. Keeping a spare block on the shelf next to the seal kit shortens the time a dispensing station sits down for an inlet-side rebuild. Torque the mounting bolts to the valve manufacturer’s spec when reinstalling, and inspect the o-ring groove for nicks before reassembly since a damaged seal face is the most common cause of a repeat leak after a block swap.

Dispensing Valve Parts: Inlet Block Specifications

Order this inlet block when a TS934A teardown shows thread wear at the fluid port, and pair it with a fresh o-ring for a clean reseal. See the rest of the service parts line under precision dispensing equipment and mixers. Techcon documents the TS934A platform on its Techcon site.

Need Help?

Need help confirming NPT port size or thread condition before you order? Call (800) 220-1966 or email [email protected].