Description
The 25 Gauge Dispensing Needle is a 0.5 inch stainless steel tip with a red hub, supplied 50 to a pack for epoxy and adhesive dispensing. The red hub follows the standard gauge color code, so an operator can grab the right bore at a glance when several sizes share a bench.
Where the 25 Gauge Dispensing Needle Works
A 25 gauge bore lays a fine, controlled bead for small dots, thin lines, and tight clearances. The half inch length keeps reach short for close work without whipping under pressure. It threads onto Luer lock barrels and syringes for hand or pneumatic dispensing of epoxies, cyanoacrylates, UV adhesives, oils, and other low to medium viscosity fluids.
- 25 gauge bore for fine bead and dot control.
- 0.5 inch stainless steel cannula with red Luer hub.
- Pack of 50 for production and repeat trials.
- Threads onto standard Luer lock barrels and syringes.
- Suited to epoxy, cyanoacrylate, UV, and general fluid dispensing.
Handling the 25 Gauge Dispensing Needle
Match the bore to the bead you want before committing a run. Too small a bore raises back pressure and slows flow on thicker material, while too large a bore floods fine detail. Start the controller at a low pressure on a test coupon, watch for stringing or clogging, and step up only as needed. Cap or discard tips loaded with cured material so the next setup starts clean.
| Property | Detail |
|---|---|
| Type | Dispensing needle tip |
| Gauge | 25 |
| Length | 0.5 in |
| Hub color | Red |
| Cannula | Stainless steel |
| Pack quantity | 50 |
Ordering Tips and Needles
Stock several gauges with your barrels and other dispensers, mixers, and nozzles for fast changeovers. For manufacturer background on the dispensing tip range, visit Techcon.
Need Help?
Need help picking a gauge for your bead size? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.