LORD Accelerator 17

LORD Accelerator 17
This is a hazardous material, shipping restrictions and surcharges may apply.


LORD® Accelerator 17 is a mix-in curative designed for use with LORD acrylic adhesives. LORD Accelerator 17, when mixed with LORD 200, 400, 500 or 600 series acrylic adhesives, creates an adhesive system that will bond a variety of prepared or unprepared metals and plastics.

Features and Benefits 

Convenient– provides room temperature cure with all LORD acrylic adhesives.

Envirnomentally Friendly– contains no solvent, nonflammable and virtually odorless

Environmentally Resistant– resists common environmental conditions when used with LORD acrylic adhesives.


Mixing– Confirm the proper mix ratio of acrylic adhesive to accelerator by consulting the appropriate LORD acrylic adhesive data sheet. Thoroughly mix the proper amount of adhesive and accelerator until uniform in color and consistency. Be careful not to whip excessive air into the adhesive system.

Heat buildup due to an exothermic reaction between the two components will shorten the working time of the adhesive. Mixing smaller quantities will minimize heat buildup.

Applying–Apply adhesive to substrate surfaces using handheld cartridges or automatic meter/mix/dispense equipment. Mate the parts within the working time of the adhesive. Clamp in position until handling strength is achieved

Curing– Handling strength and complete cure times will vary depending on acrylic adhesive used. For cure times, refer to appropriate acrylic adhesive data sheet

Write Your Own Review
You're reviewing:LORD Accelerator 17