Techcon 1201PE Dispensing Tube, Natural 0.1 in ID M/M (Pack of 10)

Description

The Techcon 1201PE dispensing tube in natural PE is dispensing valve parts for the TS1201 pinch tube pen, built with a male to male connection for setups that feed from a reservoir or extension fitting on both ends. Each pack holds ten tubes at 0.1 inch ID, sized for general two part adhesive and cyanoacrylate dispensing where UV blocking is not required.

Where dispensing valve parts route fluid to the TS1201 pen

A male to male tube connects two female ports, which fits configurations feeding the pen from a syringe barrel, pressure tank, or extension line rather than direct cartridge mounting. The natural color lets the operator see fluid movement and catch air bubbles or flow interruption before they reach the tip. Because this tube carries the only wetted path in the pen, it gets replaced between material types instead of flushed.

This part uses the same 0.1 inch ID as the standard male to female tube, so flow rate and tip compatibility stay consistent when switching connection orientation.

How dispensing valve parts fit reservoir fed setups

Choose the male to male configuration when the pen feeds from a Techcon TS1254 or TS1258 pressure tank, or from a syringe barrel with a female outlet fitting. It differs from a disposable mixing nozzle, 2 part mixing nozzle, or jb weld mixing nozzle. Those mix material at the point of dispense, while this tube only carries fluid from the reservoir to the pen.

Dispensing valve parts specifications

Order this tube when feeding a TS1201 pen from a pressure tank or syringe reservoir. For pinch tubes, pressure tanks, and pen accessories, browse dispensers, mixers, and nozzles. For TS1201 pen and reservoir compatibility, visit Techcon.

Need Help?

Need help matching tube connection orientation to your reservoir or tank setup? Call (800) 220-1966 or email [email protected].