Techcon 400 Series Receiver Head, 35cc, 6 ft Hose

Description

This receiver head is the connecting link between a pneumatic dispensing valve or controller and a 35cc syringe barrel, fitted with a Viton O-ring seal and a 6 ft air hose terminating in a male quick connector. Air pressure from the controller passes through the hose into the receiver head, which seats onto the barrel to push the plunger and dispense fluid at a controlled rate.

How a Dispensing Valve Pairs with This Receiver Head

A dispensing valve or time-pressure controller regulates the air pulse. The receiver head is what actually connects that regulated air to the syringe barrel without a hand-tightened fitting that can loosen mid-run. The quick connector lets an operator swap barrels between dispense cycles without disconnecting the hose from the controller each time, which matters on stations running multiple barrel sizes.

Where This Dispensing Valve Accessory Gets Used

Electronics assembly, potting, and conformal coating stations that dispense from 35cc syringe barrels under time-pressure control use this receiver head to make the air-to-barrel connection accident resistant. The Viton O-ring holds a seal against common solvents and resins better than standard nitrile, which matters when the dispensed material off-gases or the barrel sees repeated solvent wipe-downs.

Order this receiver head to pair a 35cc syringe barrel with an existing pneumatic controller, or as a replacement when the O-ring seal wears out. Confirm barrel capacity and hose length against your bench layout before ordering. Browse related equipment in the dispensers, mixers, and nozzles category. For controller and receiver head compatibility, see Techcon.

Need Help?

Need help matching a receiver head to your syringe barrel and controller setup? Call (800) 220-1966 or email [email protected].