Techcon 4-Position 0.156 Inch Connector Housing

Description

The Techcon 4-position connector housing is dispenser parts hardware for service work on electrical connections used around dispensing equipment. This housing uses a 4-position layout with a 0.156 inch connection format, giving maintenance teams a small replacement component for control wiring, valve interface leads, and equipment panels where the mating connector housing is worn, cracked, or no longer holding the connection securely.

Where dispenser parts support electrical connections

Automated and bench dispensing systems depend on consistent signal paths. Controllers, valves, sensors, and accessories need connectors that stay seated through repeated cycles, vibration, and service handling. A damaged housing can create intermittent behavior that looks like a controller setting, valve timing, or air-supply issue, even though the problem is a loose electrical connection. Replacing the housing during service helps restore a stable connection before a team starts changing pressure, timing, or fluid settings.

Use this housing when the existing connector body is the worn item and the terminal, lead, or mating header still matches the equipment design. Check that the 4-position count, 0.156 inch format, latch behavior, and wire-side terminal style align with the repair bill before release. Small connector differences can prevent a plug from seating fully, and a partly seated connector can cause repeat service calls after the dispenser has already been put back on the bench.

This housing should be organized with electrical repair spares, controller leads, board headers, and equipment service parts. It is separate from the wetted path and should not be confused with cartridge consumables. A mixing nozzle, 2 part mixing nozzle, and jb weld mixing nozzle are used at the cartridge outlet to blend or shape adhesive flow, while this housing supports the electrical side of the dispense station.

dispenser parts specifications

For maintenance planning, keep this housing labeled by position count and connection size so it is not mixed with similar small housings. When a connector has been overheated, pulled at an angle, or contaminated during repair, inspect both sides of the connection before replacing only the plastic body. A clean, correctly retained plug helps the controller signal reach the equipment without nuisance faults.

Ordering dispenser parts for connector repair

Order this housing when the repair calls for a 4-position, 0.156 inch connector body rather than a full controller, valve, or cable replacement. Confirm the mating header, terminal style, polarity, and equipment documentation before final assembly. For compatible valves, nozzles, fittings, and dispense-system accessories, browse dispensers, mixers, and nozzles. For broader manufacturer context on dispensing equipment families, visit Techcon.

Need Help?

Need help matching this connector housing to a controller lead, header, or valve interface? Call (800) 220-1966 or email [email protected].