Description
The Techcon TS7000 cartridge assembly housing holds the feed screw cartridge in place on the TS7000IMP rotary auger valve. It is one of the dispensing valve parts that lets a technician swap a worn feed screw and chamber without removing the entire valve from the automation cell.
Where These Dispensing Valve Parts Fit
This housing accepts the cartridge assembly and secures it with a single thumb screw, so the feed screw and chamber can be pulled and replaced in the field. The design keeps the valve on the Z-axis gantry during the swap, which cuts changeover time compared to removing the full valve body. It works with every TS7000IMP feed screw pitch: 8P, 8P high output, 16P, and 32P.
Purge TS7000IMP valves with dispensing conditioner between shifts or after every eight hours of continuous dispensing, then run a full teardown clean after about a month of service or whenever fluid starts to cure inside the chamber. A cartridge that no longer seats flush in this housing, or a thumb screw that no longer draws tight, both point to housing wear rather than a worn feed screw.
Dispensing Valve Parts Specifications
| Attribute | Detail |
|---|---|
| Compatible system | Techcon TS7000IMP rotary auger valve |
| Retention | Single thumb screw, no tools required for cartridge swap |
| Compatible cartridges | 8P, 8P high output, 16P, 32P feed screw assemblies |
| Mounting | Bolts to the TS7000IMP main housing |
Replace this housing when the thumb screw threads wear or the cartridge no longer seats securely, both common failure points on high-cycle dispensing lines. Pair it with a fresh cartridge assembly for a full rebuild. Browse our dispensing valves and mixer nozzles for compatible feed screws and syringe barrels, or see Techcon for the full TS7000IMP platform.
Need Help?
Need help identifying which cartridge pitch fits this housing? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.