Description
MACtransfer 210 is a wide format vinyl application tape built to move a weeded graphic off its liner and onto the substrate as one piece. The carrier is translucent saturated paper at 4.3 mil, coated on a single face with a medium tack pressure sensitive adhesive. It grips the cut film hard enough to pick up every letter and interior detail, holds the layout in register while the installer sets position, then releases and leaves the vinyl behind. The tape is an installation carrier. It does no bonding work.
The 54 in width is the reason to reach for this roll instead of a narrower one. A full vehicle side, a wide wall legend, or a banner face transfers without a butt joint in the paper, so there is no ridge to squeegee over and no registration drift where two strips meet. Translucent stock earns its place at this width, because reading artwork against body lines through the carrier beats guessing.
Where a 54 Inch Vinyl Application Tape Pays Off
- Full vehicle side panels, box truck lettering, and trailer wraps that must land in one pass
- Oversize wall and window graphics where a carrier seam would telegraph into the layout
- Wide banner and sign faces cut as a single legend rather than assembled letter by letter
- Multi element layouts that have to stay in register from the cutting table to the substrate
- Shielding a polished or printed face through fabrication, storage, and freight handling
Handling Wide Vinyl Application Tape Without Trapping Air
Squeegee the tape down over the weeded film with firm even pressure across the full width, so the adhesive seats into the small interior cuts and not just the open areas. Lift the graphic with its backing liner attached, then strip the liner. At 54 in, hinge the piece rather than free handing it. Tape one edge to the prepared substrate, set it, then pull the hinge and squeegee from the center outward so air moves to the perimeter.
Peel the paper back at a low angle once the film has grabbed. Lifting straight up pulls fine detail off the panel. Two sets of hands are worth having at this width, since a 54 in sheet that folds onto itself is scrap. Face stock, liner release, surface energy, temperature, and squeegee pressure all move the result, so prove the sequence on a representative piece first.
Technical Specifications
| Property | Value |
|---|---|
| Product | MACtransfer 210 |
| Type | Paper application tape, one side coated |
| Carrier | Translucent saturated paper |
| Adhesive | Medium tack pressure sensitive |
| Thickness | 4.3 mil |
| Roll Width | 54 in |
| Roll Length | 300 ft |
| Coated Face | One side |
| Primary Use | Full panel and oversize cut vinyl graphics |
| Secondary Use | Temporary protection of finished faces |
| Application Method | Squeegee transfer, two person on full width |
| SKU | MTC-ST1000W54L300 |
Choosing Between 54 In and 30 In
Match the roll to the widest graphic a shop cuts regularly, not to the largest job it has ever quoted. The 54 in roll earns its keep on full panel and wall work where a seam is unacceptable. Drop to the 30 in roll for door graphics, window lettering, and general decal work, where a narrower web is lighter on the table and easier for one person to control. Compare widths across the adhesive transfer tapes range, and see Mactac for film and application guidance.
Need Help?
Need help matching carrier tack to a vinyl face stock, or deciding between a 54 in and a 30 in web for your table? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.