Techcon Pyles 4 In. x 1/32 In. Female Buttress Nozzle, 1000 Pack

Description

The Techcon Pyles 4 inch nozzle is a dispensing needle style outlet with a 1/32 inch orifice and female buttress thread. It gives operators a long, narrow path for placing adhesive, sealant, coating, or paste into controlled locations where a short tip cannot reach cleanly. The 1000 pack is built for production use, kitting, and work cells that treat tips as single-use or shift-change consumables.

Dispensing Needle Reach and Placement

A 4 inch outlet helps reach into channels, fixture openings, recessed bond areas, and assemblies where the dispense valve or cartridge nose cannot sit directly over the target. The small orifice supports fine bead placement and reduces excess material at the start of a shot when pressure and timing are tuned correctly. Operators working with mixing nozzle systems, 2 part mixing nozzle cartridges, or jb weld mixing nozzle compatible repairs can use a long final outlet when the mixed material must be guided into a tight area after the cartridge or mixer.

Setup and Process Control

Long narrow outlets add flow resistance. For high-viscosity materials, confirm the dispenser has enough pressure and that the material can pass through the 1/32 inch opening without pulsing. Start with a test shot, then adjust pressure, shot duration, or hand speed until the bead starts and stops cleanly. Keep tips capped or bagged until use so dust does not enter the fluid path. Replace the nozzle when material begins to cure inside the opening, when bead size changes, or when the tip is bent during handling.

Quality Checks Before Use

Inspect the first few deposits under the same speed, angle, and stand-off distance planned for the job. A long tip can magnify small hand movements, so fixtures or light guides may help when the bead must land in a narrow channel. If output tails at the end of each shot, reduce pressure or shorten the dwell before lifting away. If the bead starts late, purge the tip and check for trapped air. Keep the pack organized by orifice size so similar long nozzles are not mixed during setup.

Dispensing Needle Specifications

Choose this 1000 pack for high-use benches, repair kits, or production lines that need repeatable long-reach bead placement. Browse related dispensers, mixers, and nozzles for cartridges, barrels, and alternate outlet styles. Techcon publishes its dispensing family overview at Techcon.

Need Help?

Need help matching orifice size, thread style, or tip length to your fluid path? Call (800) 220-1966 or email [email protected].