Techcon M6 x 30mm Button Head Socket Cap Screw, Stainless Steel

Description

Dispenser parts for Techcon fluid dispensing equipment include the structural fasteners used to hold housings, brackets, and mounting hardware together through repeated service and rebuild cycles. This M6 x 30mm button head socket cap screw is one of those fastener-level components, used where a low-profile rounded head fits the clearance available on a compatible Techcon assembly.

Dispenser parts specifications

• Thread: M6 (metric)
• Length: 30mm
• Head style: button head socket cap (BHSC), low profile
• Drive: hex socket
• Material: stainless steel
• Manufacturer: Techcon (OK International / Dover)

A button head socket cap screw is chosen over a flat or socket head cap screw when the assembly needs a rounded, low-profile head that will not snag on an adjacent cable, hose, or moving part, which is common around dispense stations where fluid lines and cable routing share tight clearances with mounting hardware. Getting the head style and length right avoids a common rebuild mistake: a screw that is too long for its through-hole can bottom out in the mating part before the head draws down tight, leaving the joint loose even though the screw appears fully driven.

Dispenser parts fitment

Confirm thread length against your equipment’s service drawing or bill of materials before ordering, since a 30mm screw substituted into a shorter or longer bore than specified can either bottom out early or fail to reach full thread engagement. Stainless steel is the standard material for this class of hardware because a dispense station sees regular exposure to adhesive overspray, cleaning solvents, and shop humidity, all of which accelerate corrosion and eventual thread seizure on plain steel fasteners.

Tighten to a torque appropriate for M6 stainless hardware in the base material it threads into. Over-torquing risks stripping the thread in a softer housing material, while under-torquing leaves the joint prone to loosening under the vibration a dispense assembly experiences during normal cycling. Replace washers or spacers in the same position they came out of if the assembly uses them, since swapping their order can change how the head seats.

Dispenser parts ordering notes

Stock this screw alongside other dispensers, mixers, and nozzles service hardware so a scheduled rebuild is not held up waiting on a single fastener. For manufacturer platform context, see Techcon’s fluid dispensing systems.

Need Help?

Need help confirming fastener sizing for a Techcon rebuild? Call (800) 220-1966 or email [email protected].