Description
The Techcon TS5000 valve body is the replacement housing for a TS5000 dispensing valve assembly. It supports the internal service stack, fluid path, and mounted components that let the valve control material flow in a production or bench dispensing station.
Where this dispensing valve body fits
The valve body is deeper in the repair path than a tip, tube, adaptor, or seal. It should be considered when inspection shows physical damage, thread wear, a scarred seal pocket, chemical attack, or repeated leakage that fresh seals do not correct. A damaged body can make a good controller, stable air signal, and clean material feed behave as if the whole station is out of tune.
Techcon valve stations are used to dispense adhesives, sealants, coatings, lubricants, greases, and other assembly fluids through controlled dots, beads, shots, or spray patterns. The body keeps the service parts aligned so the valve can open, close, and seal predictably. If the housing no longer holds those parts squarely, the connected fluid line, pressure pot, controller, and tip cannot make the dispense cycle consistent on their own.
dispensing valve specifications
| Property | Value |
|---|---|
| SKU | TEC5000-000-069 |
| Brand | Techcon |
| Part type | Valve body |
| Valve family | TS5000 platform |
| Use area | Precision valve repair and rebuild work |
| Unit of measure | Each |
Before ordering, confirm the valve model on the equipment tag and compare the old body to the service drawing. Many Techcon valve parts look similar across platforms, but a different body can change port position, seal fit, or hardware alignment. During repair, remove pressure, disconnect air and material, and keep screws, spacers, seals, and adaptors organized as the valve is opened. Browse related dispensers, mixers, and nozzles for matching Techcon valves, tips, tubing, and repair parts. Current dispensing platform information is available from Techcon.
Install the body with clean mating hardware and fresh seals where the repair procedure calls for them. Reusing distorted screws or cut O-rings can make the replacement body look like it is leaking. After assembly, cycle the valve with air first, then introduce a low-risk test material or approved purge method before production fluid returns to the line.
For maintenance planning, store this body as a model-specific component rather than a general shop part. A labeled spare helps reduce downtime when a valve has been damaged during cleaning, over-tightened during service, or worn enough that normal rebuild kits no longer restore dependable shutoff.
For purchasing, pair the body with the common seal kit and hardware used on the same valve family. That prevents a rebuild from stopping halfway because the housing is new but the old seals, screws, or adaptors are still worn. Keep the removed body until the repaired station has passed a short test, since damage marks can help explain the original failure and guide future service intervals.
Need Help?
Need help deciding whether the body, seal kit, or connected hardware is the right repair path? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.