TS5000 Series Dispensing Valve Body with Stainless Insert, 6W

Description

These dispensing valve parts pair a TS5000 Series valve body with a stainless steel insert, giving the bore extra resistance to abrasive and highly filled fluids that wear standard Delrin faster than a typical production schedule allows. The stainless insert sits inside the body and forms the wear surface the feed screw rides against, so the softer housing material stays protected while the insert takes the abrasion. This 6 Watt configuration is a direct fit replacement for TS5000 Series rotary valves already running on the line.

Where These Dispensing Valve Parts Fit

• Filled epoxy, ceramic-loaded, and abrasive adhesive dispensing where a standard bore wears prematurely
• High duty cycle production cells running continuous shifts with limited maintenance windows
• Solder paste and flux paste metering on SMT lines with tight repeatability requirements
• Retrofit onto existing TS5000 valve mounts without changing controller or mounting hardware

Wear inside a rotary valve rarely announces itself as a hard stop. It shows up first as a slow drift in shot weight, then as an operator adjustment to the timer or pressure to compensate, and only later as an out-of-spec part on final inspection. Stepping up to a stainless insert body ahead of that drift is a maintenance decision, not a downgrade from the standard Delrin bore. It buys longer intervals between rebuilds on any line running filled or abrasive fluid at volume.

The insert itself is replaceable separately from the outer body in most service kits, so a shop running high volumes of abrasive fluid can plan two service intervals: a shorter one for the insert and a longer one for the surrounding housing. Tracking which interval a given station is on, rather than replacing the whole assembly on every service call, keeps parts spend proportional to actual wear.

Dispensing Valve Parts Specifications

• Body variant: 6 Watt with stainless steel insert
• Valve platform: Techcon TS5000 Series rotary valves
• Wear surface: stainless steel insert bonded into a Delrin housing
• Compatible with 6, 8, and 16 pitch feed screw inserts
• Suited to medium to high viscosity fluids, roughly 30,000 to 1,300,000 cps

Order this insert body when abrasive or filled fluid is cutting valve service life short on a standard bore, or when a new cell is being specified for high volume filled adhesive work from the start. Pair it with the correct pitch feed screw, and browse Chemical Concepts dispensers, mixers, and nozzles for matching feed screws and syringe barrels. For more on the TS5000 platform’s disposable material path design, see Techcon.

Need Help?

Need help deciding between a standard Delrin bore and a stainless insert for your fluid? Call (800) 220-1966 or email [email protected].