Conap/Cytec CONATHANE ® CE-1155 Conformal Coating Kit

$360.48
SKU
CYT-CE-1155
This is a hazardous material, shipping restrictions and surcharges may apply.

CONATHANE CE-1155 is a two-component, solvent-based polyurethane printed circuit board coating designed for use in adverse environments. CONATHANE CE-1155 provides outstanding resistance to moisture and good abrasion resistance. The cured film is hard and tough and has excellent adhesion to phenolic and epoxy-glass laminates. When tested over printed circuit patterns, excellent results are obtained with 1.5 mil films. Defective components can be replaced in coated areas using ordinary repair procedures without degradation or discoloration. Spot re-coating can then be accomplished.

CONATHANE CE-1155 may be applied by spray, dip, or brush techniques and will cure at room or elevated temperatures.

The cured film is suitable for continuous operation up to 130°C.
The system contains a fluorescent dye to aid inspection under ultraviolet light.
Qualified to MIL-I-46058-C IPC-CC-830B

4 Week Lead Time When Products Not in Stock

Typical Properties of Materiial Supplied

       Property

        Conditions

                           Value          

 

 

 

  CONTHANE®CE-1155

           Part A

 Urethane Prepolymer

CONTHANE® CE-1155

          Part B

        Curative

Appearance

 

      Clear Amber

 Clear Amber

Viscosity

25 ̊C/77 ̊F

 200 - 400 cP            

  30 – 50  cP

Solids Content

 135 ̊C for 45 min.

          60 %

           65%

 Specific Gravity

 25 ̊C / 77 ̊F

          1.13    

           0.96

Flash Point

   ASTM   D93

           28 ̊C

           82 ̊F

           13 ̊ C

           55 ̊ F

 Mix Ratio

  Parts by weight

  Parts by volume

          100

          100

           70

           82

**Call For Pricing**   

Write Your Own Review
You're reviewing:Conap/Cytec CONATHANE ® CE-1155 Conformal Coating Kit