Description
dispensing valve parts in a pressure-fed adhesive station have to match the reservoir, valve, and tubing size before material reaches the dispense point. This Techcon TS1258-250 kit supplies a 1/4 inch outside-diameter fluid-line package for pressure pots, with polyethylene tubing, a fitting, and ferrules for a controlled feed path from the tank toward the valve or manifold.
dispensing valve parts for 1/4 inch tubing
The 1/4 inch size is a common choice on TS1258 pressure-pot setups where the material path needs more capacity than a 4mm line but does not require the larger 3/8 inch option. It helps maintenance teams replace worn tubing, standardize a fluid line, or prepare a second feed setup for a different material without improvising individual fittings from mixed bins.
Pressure-pot dispensing depends on the whole path staying clean and correctly sized. The tubing carries adhesive, sealant, coating, or resin from the reservoir to the valve area, while the compression hardware has to grip without distorting the tube. Use the clear line for general visibility during setup and troubleshooting, and reserve opaque line use for materials that should see less light during staging or production.
dispensing valve parts installation notes
Shut pressure off before servicing the line. Thread the fitting into the matching port, feed the tubing through the nut and ferrule stack, and tighten the connection enough to seal without pinching the line closed. Route tubing away from sharp bends, hot surfaces, and moving equipment. Once assembled, pressure-test the connection before starting production material flow, then purge the line so air does not interrupt dots, beads, or metered shots.
Specifications
| Spec | Detail |
|---|---|
| SKU | TECTS1258-250 |
| Product type | Pressure-pot fitting and tubing kit |
| Tube size | 1/4 inch outside diameter |
| Tubing material | Polyethylene |
| Connection style | Compression fitting with ferrules |
| Typical use | Fluid feed line for Techcon pressure-pot dispensing |
Choose this kit when a TS1258 station needs a 1/4 inch replacement line or a matched accessory set for a new material path. For adjacent tanks, valves, mixers, and tubing accessories, browse dispensers, mixers, and nozzles. For broader Techcon system context, visit Techcon.
Need Help?
Need help confirming whether 1/4 inch tubing is the right feed size for your material? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.