Techcon TSD126-224PK Fluid Line Assembly, 0.100 in ID x 24 in

Description

Techcon TSD126-224PK dispensing valve parts keep adhesive and sealant material moving from a reservoir, syringe, or pressure-fed setup to the dispense point. This 0.100 in ID x 24 in natural polyethylene fluid line assembly has a female Luer/open configuration and is sold in a quantity of 10. The molded Luer fitting connects with standard Luer lock dispensing components, helping maintenance teams replace a worn or contaminated line without changing the whole valve station.

Where dispensing valve parts fit

Use this line assembly when a benchtop, fixture-mounted, or pneumatic dispense system needs a clean replacement path for low to medium viscosity fluids. It belongs with the same family of dispensers, mixers, and nozzles used for production bonding, potting, gasketing, and sealant application. The 24 in length gives operators reach without adding excess hose that can trap material or delay response at the dispense tip.

How it supports dispensing valve parts selection

The 0.100 in internal diameter balances flow and control for small adhesive beads, primers, resins, and similar fluids. Techcon states that TSD126 fluid line assemblies use molded Luer fittings and handle up to 100 psi working pressure. When troubleshooting a dispense cell, check whether the fluid line, mixing nozzle, 2 part mixing nozzle, or jb weld mixing nozzle is the restriction before changing controller settings. A fresh line can restore cleaner startup, reduce trapped cured material, and help keep the dispense path consistent between production batches.

Specs

Order this line assembly when preventive maintenance calls for replacing wetted tubing, when a fluid change requires a clean path, or when a Luer-connected station needs a matching 24 in polyethylene line. For Techcon family context, visit Techcon.

Need Help?

Need help matching a fluid line to your valve, fitting, or dispense tip? Call (800) 220-1966 or email [email protected].