Techcon 533 Hose Connector, Black

Description

A worn or cracked fitting is one of the more common dispenser parts to fail on a bench dispensing setup, and this black hose connector replaces the air-line coupling on Techcon fluid dispensers. It threads into the dispenser’s air inlet and accepts standard push-in tubing, keeping the pneumatic supply sealed at working pressure.

Where This Dispenser Parts Fitting Gets Used

The connector mounts on Techcon manual and pneumatic dispensers that regulate air pressure to a syringe barrel or cartridge. Any dispenser running on shop air needs a tight connection at this joint. A loose or aged fitting leaks pressure, which shows up as inconsistent shot size or a dispenser that will not build to its set pressure.

How This Dispenser Parts Fitting Holds Up

The connector body is molded in a black polymer sized to standard push-in tubing, and it holds a seal under the pressure ranges typical of bench dispensing (well under 100 psi). Because it is a small, low-cost wear item, keeping a spare on hand avoids downtime when a fitting cracks or the tubing seat wears out from repeated connect and disconnect cycles. Replacing the connector at the first sign of a slow leak is far less disruptive than troubleshooting a dispenser that intermittently under-pressurizes mid-shift, since a partial leak can masquerade as a regulator or valve problem until the fitting itself is checked.

Order this connector as a direct replacement when the air line fitting on your dispenser cracks, loosens, or stops holding pressure. Pair it with the matching air hose from our dispensing, mixing, and nozzle accessories category. Techcon’s full fitting and accessory range is on its manufacturer site. Keeping two or three spare connectors on hand costs little next to the downtime a single cracked fitting can cause mid-shift.

Need Help?

Need help identifying which hose connector fits your Techcon dispenser model? Call (800) 220-1966 or email [email protected].