Medmix 50ml Empty 1:1 Ratio Greenline 2-Part Cartridges with Pistons & Sealing Caps (AB 050-01-13-33)

Description

The Medmix (Sulzer Mixpac) 50ml Greenline 1:1 cartridge is an empty two-part cartridge built for storing and dispensing two-component adhesives, epoxies, urethanes, and silicones that mix at an equal 1:1 ratio. Each cartridge ships with matching pistons and a re-sealable cap, so it is ready to fill, store, and dispense. Greenline is the bio-based, sustainable cartridge line from Medmix, molded from 100% post-consumer recycled polypropylene. You get the metering accuracy and process safety of a standard B-System cartridge with a lower waste footprint.

The two barrels keep both adhesive components separate until you attach a static mixer. A matching 50ml dispensing gun pushes both parts through the mixer in the correct proportion, so the material arrives blended and ready to apply. The coded interface and separate outlets help prevent cross-contamination between sides.

Benefits

• 100% post-consumer recycled polypropylene for a lower waste impact
• Accurate 1:1 metering with minimal dead volume and high yield
• Includes matching pistons and a re-sealable cap for filling, storage, and resealing
• Leak-resistant design with long-term storage stability
• Coded interface and separate outlets reduce cross-contamination

Common Applications

• Filling and dispensing two-component epoxies, urethanes, and silicones at a 1:1 ratio
• Industrial bonding, potting, and sealing where precise metering matters
• Small-batch and production runs that need a clean, repeatable adhesive process

Surface Prep and Use

Fill each barrel with the matching component, insert the supplied pistons, and seat the cap until you are ready to dispense. Load the cartridge into a matching 50ml two-component gun, attach a static mixer, and dispense a short purge to confirm even flow before applying to your part. Surfaces should be clean, dry, and free of oil or release agents for the best bond. Follow the adhesive manufacturer instructions for mix length, working time, and cure.

Ordering and Product Support

This listing is for the empty cartridge with pistons and sealing cap. You will also need a matching 50ml 1:1 dispensing gun and static mixers to apply two-component material. See our full range of dispensers, mixers, and nozzles to complete your setup. Manufacturer information is available at medmix.swiss. For help selecting the right gun, mixer, or quantity, call Chemical Concepts at (800) 220-1966 or email [email protected].