Techcon TSD1400-014BPK Viton O-Ring, 1/2 In. ID

Description

dispensing valve parts like the Techcon TSD1400-014BPK O-ring support valve service when the assembly calls for a 1/2 inch ID x 1/16 inch C.S. Viton seal. The brown Viton material callout helps separate this part from similar Buna and EPR seals in the same drawer. Keep it near mixing nozzle, 2 part mixing nozzle, and jb weld mixing nozzle inventory so seal service and dispensing setup supplies stay close to the equipment.

Where dispensing valve parts Fit

Use this O-ring only when the part number and material match the service need. A correct diameter is not enough by itself. The removed seal, fluid exposure, valve family, and service list should all point to Viton before this part is installed. If the old seal shows swelling, cuts, or compression set, inspect the surrounding hardware before reassembly.

• 1/2 inch ID x 1/16 inch C.S. Viton replacement seal.
• Ten-pack supply supports planned service and repeated rebuilds.
• Brown material cue helps technicians distinguish Viton from other seal compounds.
• Useful for compatible dispensing valves, fittings, and fluid-control hardware.

Handling and Service Notes

Clean the groove, stem, bore, and mating surfaces before installing the replacement. Keep the seal free of dust, chips, and cured material. Seat it evenly without twisting. After assembly, run a controlled test at normal operating conditions and check for leak behavior, pressure loss, and repeatable shot size before releasing the station.

Technical Specifications

Ordering dispensing valve parts

Order this seal when the service task calls for TECTSD1400-014BPK. For related valves, tubing, fittings, and tips, browse dispensers, mixers, and nozzles. Current manufacturer information is available from Techcon.

Need Help?

Need help confirming seal material or service fit for your valve? Call (800) 220-1966 or email [email protected].