Techcon Production Master Hose Assembly

Description

This master hose assembly carries regulated shop air from a pneumatic controller or dispensing valve to a handheld dispensing gun on a production line. It replaces a worn or damaged primary air line without requiring a full controller rebuild, and it is built to the same pressure rating as the guns and valves it feeds.

Where This Dispensing Valve Hose Gets Used

• Production stations where the primary air line between the controller and gun has worn, kinked, or lost its seal at the fitting
• Multi-shift lines that keep a spare master hose on hand to avoid downtime waiting on a replacement order
• Bench setups pairing a pistol grip or palm grip gun with an existing dispensing valve or time-pressure controller

Fit and Handling

The hose connects at both the controller or valve end and the gun end using the same fittings as the original equipment, so installation is a direct swap without adapters on most Techcon-compatible setups. Rated to standard 100 PSI (6.9 bar) shop air, the assembly holds a seal under the pulsed pressure cycles typical of pneumatic dispensing rather than steady-state air tool use. Inspect the hose periodically at the fitting ends, where flex fatigue shows up first on high-cycle lines.

Dispensing Valve Hose Specs

• Type: Production master hose assembly
• Maximum pressure: 100 PSI (6.9 bar)
• Connection: Direct fit, controller or valve to gun
• Part Number: 918-000-002

Order this hose assembly as a direct replacement when the primary air line to a production dispensing gun fails or wears at the fitting. Confirm fitting style against your existing setup before ordering. Browse related equipment in the dispensers, mixers, and nozzles category. For hose and fitting compatibility, see Techcon.

Need Help?

Need help matching a replacement hose to your dispensing gun and controller? Call (800) 220-1966 or email [email protected].