Description
The Tensor M125 wand spray gun puts 18 inches of reach between your hand and the spray tip, so pressurized canister adhesive goes down on floors, roof decks, and low panels without constant stooping. The gun threads onto the hose of a canister adhesive system, and a trigger meters flow through a wide fan web-spray tip that covers broad surfaces quickly and evenly.
Where the M125 Wand Spray Gun Works
- Single-ply roofing membrane adhesives on TPO and EPDM decks
- Flooring, turf, and insulation adhesives broadcast over large areas
- Panel lamination and substrate tack coats that sit below bench height
- Any canister application where repeated bending and reaching wears the operator down
The wand format pairs with web-spray canister adhesives across brands. Check the adhesive technical data sheet for tip guidance, then set canister pressure to the adhesive maker’s stated range before pulling the trigger. Output volume and fan width track canister pressure, so a quick test spray on scrap cardboard confirms the pattern before the first production pass. Once dialed in, the long wand holds a consistent standoff distance, which keeps coverage uniform across the whole surface.
M125 Wand Spray Gun Setup and Care
- Threads onto standard pressurized adhesive canister hoses, including TensorGrip systems
- 18 inch rigid wand extension keeps the spray tip at the work surface
- Trigger control meters output from a light tack coat to full coverage
- Replaceable web-spray tip lays down a wide fan pattern that trims application time
- At shift end, purge with the adhesive manufacturer’s recommended solvent and cap the tip to keep the next start clean
Find companion tips, hoses, and applicators in our dispensers, mixers, and nozzles category. The M125 comes from Tensor, the Quin Global brand behind the TensorGrip canister adhesive line.
Need Help?
Need help matching a wand gun to your canister adhesive system? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.