Techcon 700 Series 10cc Receiver Head Assembly with 3 ft Hose

Description

The Techcon 700 Series 10cc receiver head assembly is the connecting link between a syringe barrel and a time and pressure dispensing valve or controller. The assembly includes a receiver head fitted with a Viton O-ring, a 3 ft length of pressure hose, and a male quick connector, so it drops into an existing 700 Series setup without cutting or fitting hose by hand.

Where the Dispensing Valve Connection Lives on the Line

Benchtop dispensing stations built around a 700 Series barrel and a controller need a sealed path for regulated air to reach the piston. This receiver head assembly forms that path, seating on the back of a 10cc syringe barrel and routing air pressure from the controller down the hose on command. Electronics assembly, small parts bonding, and potting stations that cycle barrels throughout a shift rely on a receiver head built to hold a consistent seal shot after shot.

The Viton O-ring inside the receiver head resists the range of adhesives, solvents, and cure chemistries that can migrate back through a barrel over time, which keeps the seal from swelling or cracking under repeated use. Because the hose ships pre-cut to 3 ft, an operator swaps a worn assembly for a new one and is back in production without measuring or trimming tubing on the bench.

How the Dispensing Valve Assembly Holds Up

Maximum operating pressure on the 700 Series platform is 100 psi (6.9 bar), and the receiver head, hose, and quick connector are rated to match. A 6 ft hose version covers stations set farther from the controller, while this 3 ft version suits benches where the controller sits close to the work area. An optional inline filter is available for lines running barrels without a fitted piston, to keep fluid from migrating back into the controller.

Stock a receiver head assembly as a maintenance spare alongside your 700 Series barrels and pistons. A worn O-ring or a kinked hose is a common source of inconsistent shot volume, and swapping the full assembly resolves both at once rather than troubleshooting the fitting piece by piece. Pair it with 10cc barrels in natural, amber, or black to match the light sensitivity of the material running that day.

Order this receiver head assembly to keep a benchtop or automated dispensing valve station running without downtime for hose or seal repair. Browse the full dispensing equipment, mixers, and nozzles category for matching barrels, pistons, and dispense tips. For fitting and hose length options across the 700 Series line, see Techcon.

Need Help?

Need help sizing hose length or connector type for your dispenser setup? Call (800) 220-1966 or email [email protected].