Description
The Techcon 400 Series 1cc manual plunger is a clear polypropylene rod that clips to the rubber piston seated inside a 1cc syringe barrel, letting an operator dispense by hand instead of running a barrel off a controller.
Where a 1cc Syringe Barrel Manual Plunger Gets Used
Bench technicians and repair stations reach for the 1cc manual setup when a job needs only a drop or two of adhesive, flux, or lubricant and does not justify hooking a barrel up to an air-powered controller. Prototype builds, rework stations, and low-volume assembly cells are the typical users, since a manual plunger lets an operator meter a small dose by feel without dedicating a controller channel to a job that runs a handful of parts a day.
How the Syringe Barrel Plunger Holds Up
The plunger body is polypropylene, molded 2.57 inches (65.3 mm) long with a 0.30 inch (7.6 mm) outside diameter and a 0.22 inch (5.6 mm) inside diameter sized to clip onto the 1cc rubber manual piston. The barrel end uses a Luer slip connection, matching the fitting on the Techcon 1cc syringe barrel it seats into. Because there is no air line or controller in the loop, there is nothing to calibrate or leak-check before use, just clip the plunger to the piston and press.
Specs
| Attribute | Detail |
|---|---|
| Compatible barrel size | 1cc (Techcon 400 Series manual) |
| Material | Polypropylene |
| Length | 2.57 in (65.3 mm) |
| Outside / inside diameter | 0.30 in (7.6 mm) / 0.22 in (5.6 mm) |
| Connection | Luer slip |
Pair this plunger with a 1cc barrel and rubber piston to build a complete hand-dispensing setup for small touch-up jobs. Browse Chemical Concepts dispensing supplies for matching barrels and pistons, and see the Techcon product line for the full 400 Series manual dispensing range.
Need Help?
Need help matching this plunger to the right barrel and piston for a hand-dispensing job? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.