Techcon 700 Series 3cc Receiver Head Assembly, 3ft Hose

Description

The Techcon receiver head assembly for the 700 Series 3cc format comes pre-built with a 3-foot hose and quick connector, so it delivers regulated air straight from your dispensing valve controller to a 3cc syringe barrel without a separate hose-fitting step on the bench.

Where This Techcon Receiver Head Gets Used

Production lines running Techcon TS700 barrels use this assembly to connect a fresh 3cc barrel to the controller in one motion instead of fitting a bare receiver head and cutting hose to length by hand. That matters most on lines that swap barrels often, where a pre-measured 3-foot hose keeps every station wired the same way and cuts setup time between jobs. Electronics assembly, potting, and light-adhesive dispensing lines are the most common users, since they tend to change fluid or barrel size several times a shift.

How This Dispensing Valve Assembly Holds Up

The receiver head body is Delrin with a fitted Viton o-ring, rated to 100 psi (6.9 bar), the same seal and pressure rating as the bare receiver head. The added 3-foot hose and male quick connector are sized to snap into a standard Techcon dispensing valve controller without adapters. An in-line fluid filter is available as an add-on option for setups where a dropped or inverted barrel risks pulling fluid back into the air line, worth considering on any line running expensive or hard-to-clean adhesive.

Specs

Order enough assemblies to wire every dispensing station the same way, so any barrel drops into any station without hunting for spare hose. Browse Chemical Concepts dispensing supplies for compatible barrels and pistons, and see Techcon for the full 700 Series dispensing system.

Need Help?

Need help sizing this assembly to your controller and barrel count? Call (800) 220-1966 or email [email protected].