Description
The Techcon 45 degree nozzle spreader is a dispensing needle accessory for spreading material as it exits the fluid path. The 1/2 inch by 1/16 inch outlet helps form a flatter, wider bead than a round tip, while the angled body gives the operator better approach control when working along panels, edges, joints, and shallow recesses. The 50 pack supports production benches that replace tips during material changes or shift cleanup.
Dispensing Needle Applications
Use this spreader where a narrow round deposit would create too much height or require a second tooling pass. It can help place adhesive, sealant, coating, paste, or grease in a controlled band during assembly and repair work. The 45 degree angle helps keep the handpiece or hose out of the work surface, which is useful when following a straight edge or applying material near a corner. Keep the pack near dispensing tip inventory, mixing nozzle supplies, and 2 part mixing nozzle consumables so operators can change the outlet style without leaving the workstation.
Fit, Flow, and Setup Notes
Before production use, confirm the thread style and fluid path match the dispenser or valve being used. A spreader tip changes the bead shape, so pressure, shot time, or traverse speed may need adjustment compared with a straight round outlet. Start with a short test bead on scrap, inspect the width and edge definition, then adjust material pressure or hand speed. For filled or fast-curing materials, purge promptly and replace the tip once material begins to skin inside the outlet. A jb weld mixing nozzle compatible setup still needs the right final outlet when the bead has to be flattened after mixing.
Quality Checks Before Use
Check the first part after every tip change. The spreader should leave a consistent band with clean edges and no heavy ridge at the start or stop point. If the bead curls, skips, or narrows, inspect for cured material in the slot and verify the pressure setting. For automated or fixture-guided work, mark the approved tip angle and travel direction so each operator loads the same outlet orientation. Store unused spreaders in their pack until needed, since dust or shop debris inside the slot can affect the first bead.
Dispensing Needle Specifications
| Attribute | Value |
|---|---|
| Brand | Techcon |
| Part type | Nozzle spreader |
| Outlet size | 1/2 in. x 1/16 in. |
| Angle | 45 degrees |
| Pack quantity | 50 |
| SKU | TECTS1050-45PK |
Order this pack when the process calls for a flatter bead profile from a controlled dispensing setup. Browse related dispensers, mixers, and nozzles for compatible tips, cartridges, and accessories. Manufacturer line information is available from Techcon.
Need Help?
Need help matching outlet width, angle, or tip style to your material flow? Call (800) 220-1966 or email [email protected].
Reviews
There are no reviews yet.