Techcon Pressure Gauge, 0-100 PSI

Description

This Techcon 0-100 PSI pressure gauge gives a direct, plain-face readout of line pressure on a pneumatic dispensing system, letting an operator confirm the regulator is holding the pressure a job requires before running product. It is one of the dispenser parts that belongs on any pneumatic dispensing valve setup where consistent bead size and dot placement depend on knowing exact air pressure at a glance rather than guessing from a regulator dial alone, especially on jobs with tight process windows.

Dispenser Parts Specifications

Dispenser Parts for Pressure Verification

A regulator alone cannot confirm what pressure is actually reaching the valve, since regulator dials drift and lines can develop small leaks over time. Pairing a dedicated gauge with the regulator lets an operator verify pressure at the point of use, catch drift before it affects a production run, and document the pressure setting used on a given job so it can be repeated exactly on the next run without trial and error. A quick visual check against this gauge takes seconds and can prevent an entire batch from running out of spec.

Where This Part Fits in a Dispensing Setup

This gauge mounts inline with Techcon TS-series pneumatic dispensing valves and other pneumatic dispensing hardware in CC’s dispensers, mixers, and nozzles line. It is a direct fit replacement for a cracked, stuck, or missing factory gauge, and keeps pressure verification accurate without replacing the regulator itself, which keeps repair costs down on an otherwise functioning air supply.

Full specifications on the Techcon pneumatic dispensing line are available from Techcon. Chemical Concepts stocks this and other dispenser parts for pneumatic dispensing systems used across electronics assembly, general manufacturing, and specialty bonding lines. For fit or compatibility questions, call (800) 220-1966 or email [email protected].