Techcon TS14-1/2M Metal Dispensing Tip, 14 Gauge x 0.5 Inch

Description

Techcon TS14 tip is a straight blunt metal dispensing needle for controlled fluid placement in adhesive, sealant, ink, oil, and assembly work. The TS14-1/2M-500 configuration uses a 14 gauge stainless steel cannula, aluminum hub, and 0.5 inch length for short-reach dispensing.

Techcon TS14 tip Benefits

• 14 gauge opening supports higher-flow materials where a fine plastic taper tip would restrict output.
• 0.5 inch cannula length keeps the tip close to the work for bead placement, dotting, and wet-out.
• Stainless steel cannula resists bending better than soft plastic tips during controlled contact with fixtures or parts.
• Aluminum hub gives operators a rigid connection point for repeatable syringe-barrel dispensing.
• Straight blunt style helps place material into channels, corners, and small bond areas without a sharp needle point.

This dispensing tip is useful when the job calls for more control than a wide nozzle but more flow than a fine needle. It is commonly chosen for production cells where the material, bead width, and fixture access are already defined.

Techcon TS14 tip Applications

• Applying adhesive beads into narrow metal, plastic, or composite assemblies.
• Depositing sealant, grease, oil, or masking material in short-reach fixture pockets.
• Controlled dot dispensing for electronics, lighting, signage, and small-part assembly.
• Bench repair work that needs a rigid metal tip rather than a flexible plastic taper.
• Process trials where gauge, length, and package quantity must be documented.

Surface Preparation And Dispensing Notes

Confirm that the fluid is compatible with a metal cannula and that the selected gauge can pass any fillers without clogging. Clean the substrate according to the material supplier’s instructions, then test bead size on scrap before moving to production parts.

For repeat work, keep the dispense pressure, shot size, material temperature, and dwell time consistent. Replace tips when cured material, dried coating, or damaged cannula ends start changing the bead.

Technical Details And Documentation

Verified details for TS14-1/2M-500 include 14 gauge size, 0.5 inch length, stainless steel cannula, aluminum hub, and 500 piece manufacturer pack. Review current product and catalog information from Techcon before locking the tip into a production process.

Dispensing And Ordering Help

Order by the full manufacturer part number when pack size matters, because similar TS-M tips are available in other gauges and lengths. For related needles, mixer nozzles, cartridges, and guns, see Chemical Concepts dispensers, mixers, and nozzles.

For help checking gauge, length, hub style, or material flow before you buy, contact Chemical Concepts at (800) 220-1966 or [email protected].